THG Heat Tape Connection How To

How To Connect Heat Tape Tutorial

Of course, the simplest way to connect the heat tape is just to have us at Pangea do it for you. When you order the connection kit for your THG heat tape just select "Yes Please" under the Connect it for our option.

You can Purchase the heat tape and all accessories HERE.

Place a mark on the copper strip of the heat tape about 1/4 of an inch in from the end.

Punch a hole through the copper strip where you have marked it. A regular old paper hole punch will work just fine.



Insert the eyelet BETWEEN the the plastic layers. It is important not to go on top of or underneath but actually get inside the and between the laminate.


Once inside line up the eyelet with the punched out hole and place the longer end of the rivet through the tape and eyelet.




Next, connect the smaller part of the rivet with the other end of the rivet.




Using a special crimping tool or a good pair of vice grips, crimp the rivet together completely.  The rivet should not move at all if this is done properly.




Use the provided insulation pieces to make a "heat tape taco" around the connection on both sides.





Use electrical tape to cover the ends of the heat tape and you are done.